If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Somehow [MENTION=13436219]Emaresee[/MENTION] got in there before my post which was after [MENTION=13448813]SHAMZ84[/MENTION]'s! Things must be getting exiting...
P.s. how's the thumb?
.--
I think I may finally have this CAD under control...
Cheers @moteyi [emoji16] . . . P.s. how's the thumb?
Apparently knife blades have two sides - one you can press on and one that you can't - unless you want to produce copious quantities of claret that is! I did it whilst trying to remove silicone sealant from a recessed sink so I could replace the vanity unit work top. Main concern is getting to the van and the first aid kit without making a mess!
Comment